Grass Valley Kaleido-X v.7.80 - Manual (Page 74)

66
Operation of the Monitor Wall
Changing the IP Address of a Multiviewer from the Monitor Wall
To enable EDID auto-detect for a display
1 Right-click the monitor wall background, and then click Display Resolution on the
menu.
2 Select the Use detected monitor resolution check box.
3 Click OK.
Changing the IP Address of a Multiviewer from the Monitor Wall
With a Kaleido-X, or Kaleido-X16, you can set the IP address, system name, and other
parameters via a control panel on the monitor wall.
• The monitor EDID auto-detection feature is enabled by default in order to
facilitate the initial setup of a Kaleido-X system. Setting an output head to
a specific resolution, from a multiviewer service panel in iControl (if
available), from the monitor wall (Kaleido-IP, Kaleido-X, Kaleido-X16), or
from a Densité controller’s local control panel (Kaleido-MX, Kaleido-MX 4K,
Kaleido-Modular-X, KMV-3901/3911, Kaleido-XQUAD) disables the EDID
auto-detection for this head.
Notes (continued)
Notes
This section does not apply to the KMV-3901/3911, Kaleido-XQUAD,
Kaleido-MX, Kaleido-MX 4K, and Kaleido-Modular-X. For these multiviewers,
you can configure the network settings by using XAdmin, the Densité
controller’s local control panel (or a control panel in iControl, if available).
See
Configuring a Multiviewer’s IP Settings on page 476, or refer to the Quick
Start Guide for your multiviewer, for details.
In the case of a Kaleido-IP, changing the multiviewer’s network settings from
the monitor wall is not yet supported.