Grass Valley Kaleido-X v.7.80 - Manual (Page 64)

56
Operation of the Monitor Wall
Changing Crosspoints
Changing an Internal Router Crosspoint
To change a crosspoint in the internal router
1 Right-click the appropriate composite or video monitor on the monitor wall.
2 On the menu, point to Send to [router] output (where [router] will be the name of the
first logical router mapped to your multiviewer’s router outputs), navigate to the
appropriate logical output, and then select it.
The source signal displayed on the monitor is routed to the selected destination.
Notes
• This feature is only available on Kaleido-X (7RU), Kaleido-X (14RU), and
Kaleido-X16 multiviewers, with the SDI Router Output option, and whose
internal router is properly configured within the first level of the KX Router
logical router. See
Configuring a Multiviewer’s Internal Router on page 385
for more details.
• In the case of a Kaleido-X (14RU) expansion system, to be able to send a
video signal to a router output on either frame, the internal routers must
be connected by expansion cables, and router expansion must have been
properly configured in XEdit. Refer to “Configuring Router Card Expansion”
in the Kaleido-X (7RU) Hardware Description & Installation Manual, for
more information.