Grass Valley Kaleido-X v.7.80 - Manual (Page 479)

471
Kaleido-X
User’s Manual
Network Considerations & Port Usage
Network Considerations
Kaleido-X, Kaleido-X16, Kaleido-Modular
Kaleido-X, Kaleido-X16, and Kaleido-Modular multiviewers generate a low to moderate
amount of client-to-server data traffic, and therefore have a minimal bandwidth impact on
a network.
Error during firmware
upgrade. Duplicate IP has
been detected. We cannot
continue checking the
Firmware version. This message will appear if duplicate IP addresses are
detected between different KXO cards in the frame. As
long as this is the case, no upgrade is possible. You
must resolve the duplicate IP address issue before
resuming the upgrade. x x
Error during firmware
upgrade. The current
firmware version could
not be verified. This message will appear if software cannot retrieve
firmware version from the cards. This may indicate an
issue with the hardware. x x
Error during safemode
upgrade. The current
safemode version could
not be verified. This message will appear if software cannot retrieve
safemode version from the cards. This may indicate an
issue with the hardware. x x
Error during safemode
upgrade. Card presence
from frame B could not be
verified. This message will appear as a side effect of the
presence of cards in Frame B running a version older
than version 3.00. The upgrade will not be permitted
on any card in the frame until these cards are removed
from Frame B. To upgrade these cards, transfer them
to Frame A. x
Cannot upgrade card in
this slot (if any). Please
remove card from [slot
number]. This message will appear on an expansion frame if
Frame B contains cards running software or firmware
older than version 3.00. The upgrade will not be
permitted on any card in the frame until these cards
are removed from Frame B. To upgrade these cards,
transfer them to Frame A. x
Cannot upgrade card in
this slot. Move card to
frame A or swap with card
in frame A. Upgrade will
proceed after current
upgrade. This message will appear on an expansion frame if
Frame B contains cards running software or firmware
older than version 3.00. The upgrade will not be
permitted on any card in the frame until these cards
are removed from Frame B. To upgrade these cards,
transfer them to Frame A. x
Cannot continue the
upgrade until card in this
slot is moved to frame A. This message will appear on an expansion frame with
expansion enabled and with cards in Frame B running
software or firmware older than version 3.00. To
upgrade these cards, transfer them to Frame A. x
Message Description 7RU 4RU