Grass Valley Kaleido-X v.7.80 - Manual (Page 66)

58
Operation of the Monitor Wall
Using Timers
This allows using the numeric keypad on an external keyboard connected to the Kaleido-
RCP2 to control the timer.
Controlling a Timer by Using the Timer Monitor’s Buttons and the Menu
.
To configure an interactive timer monitor on the monitor wall
1 Right-click the timer you wish to configure.
2 On the menu, point to Mode, navigate to the appropriate timer mode, and then click
the desired end behavior.
Notes
• Timer monitors display time in HH:MM:SS format. Even if the monitor is
synchronized with an LTC source, frame count is not displayed.
• Using a timer monitor’s Reset, Timer mode or End behavior buttons will
stop the timer, if it was running.
Reset Timer mode End behavior Start/Stop
Stop
Remaining
Loop
Down
Overrun Up