Grass Valley Kaleido-X v.7.80 - Manual (Page 498)

490
Administration and Servicing
Assigning an IP Address to Each Device in your System
The Audio Bridge Terminal (ABT) is an external audio multiplexer/serializer for Kaleido
multiviewers. The ABT provides connector space for audio signal inputs, and multiplexes all
the audio signals into combined serial feeds on coaxial cables that connect to the
multiviewer’s input modules.
To configure the IP address and other network settings of the ABT
1 Connect a PC to a switch.
2 Referring to Changing the Client PC’s IP Address , on page 480, configure the PC with
the following network settings:
3 Apply power to the Audio Bridge Terminal and make sure it is connected to the same
switch as the PC. If the switch is Power over Ethernet (PoE) enabled, simply connect it to
the unit using an Ethernet cable. If not, PoE mid-span (“inserter”) equipment must be
placed between the switch and the Audio Bridge Terminal.
4 Press the RESET button (located on the right-hand side of the ABT rear panel beside the
ETHERNET/POWER RJ-45 connector) for at least 1 second. The Audio Bridge Terminal
will reboot with the following static network configuration:
Note: The ABT is powered through the RJ-45 Ethernet connector. There is
no power ON/OFF button, so the device is ON whenever a powered Ethernet
cable is connected.
DHCP Off
Static IP address 10.0.0.1
Subnet mask 255.255.0.0
Default gateway 10.0.0.1
DHCP OFF
Static IP address 10.0.3.190
Subnet mask 255.255.0.0
Default gateway 10.0.0.1