Grass Valley Kaleido-X v.7.80 - Manual (Page 225)

217
Kaleido-X
User’s Manual
Configuring Custom Resolutions from the Tools Menu
To create a custom display resolution from the Tools menu
1 On the Tools menu, click Edit resolutions.
The Edit Resolution Settings window appears.
2 Select the resolution you wish to customize (or the one on which you wish to base a
new resolution), from the list at the bottom of the window.
3 Under either the Porch or the Modeline section—depending on whether you prefer to
specify front porch, back porch, sync, and active values, or blank start, sync start, sync
end and blank end—, set the refresh rate and other timing parameters so that they
match those of the physical display you need to configure.
Note: When you modify one of the default resolutions, you can only save
your changes as a new resolution. On the other hand, custom resolutions
can be tweaked and saved repeatedly until the desired configuration is
achieved. However, make sure that the active width and active height values
you specify match those of one of the default resolutions, otherwise your
custom resolution will be ignored.