Grass Valley Kaleido-X v.7.80 - Manual (Page 146)

138
Calibrating the Kaleido-X
Multiviewer Input Calibrations
3 Expand the appropriate input.
4 Expand Audio programs & loudness, and then click Program 1.
5 In the Properties pane, select the embedded audio channels that you want to be part
of the audio program.
Each channel is assigned a specific role in the program (left, right, center, etc).
6 Repeat the procedure to define a second audio program (Program 2), if you wish.
Audio channels can be reused to define the second program or they can be made
mutually exclusive as desired.
Calibrating Loudness Measurement
To calibrate loudness measurement
1 Navigate to the appropriate input’s Loudness element in the System list or audio
profile, and select it.
• In the case of a Kaleido-IP, see Navigating to the loudness calibration in a
Kaleido-IP calibration profile , on page 139.
• For a Kaleido-X16 or a Kaleido-X, see Navigating to the loudness calibration in a
Kaleido-X16 or Kaleido-X System list , on page 140.
Note: This section applies to Kaleido-IP, Kaleido-X16, and Kaleido-X with
second-generation input cards (KXI-16SV rev. 600 and later, KXI-16HS3, and
KXI-16HSV3).