Grass Valley Kaleido-X v.7.80 User Manual
Page 538
530
Administration and Servicing
Adding Fonts to a Kaleido-IP
3 Click Configure, under Font configuration.
The “Font configuration” page appears.
4 Click Choose a font to upload.
A file chooser window appears.
5 Navigate to the font file you wish to upload, select it, and then click Open.
A progress indicator appears momentarily, followed by a confirmation message.
6 Click Restart unit.
The system prompts you to confirm.
7 Click Yes to proceed.
Your multiviewer will shut down, and then start again. This may take a while.
Once the multiviewer has restarted, the system notifies you.
8 Click OK.
The XAdmin Status and Options page appears.
9 Make sure the same font is available on the client PC or laptop where you use XEdit. (To
install a font on Windows 7, right-click the TTF file, and then click Install.)
10 Close XEdit and then open it again (see
The new fonts are now available, if you:
• Connect XEdit to the multiviewer (see
Note:
The Kaleido-X software supports true type fonts (TTF) only.