Grass Valley Kaleido-X v.7.80 - Manual (Page 62)

54
Operation of the Monitor Wall
Changing Crosspoints
4 Click Take.
The selected logical source is now assigned to the monitor.
5 Click the × button to close the Assign Source window.
Changing Crosspoints
Changing Logical Sources Assignments on a Kaleido-X Configured as a
Router
To change a monitor’s source assignment by using a router control device or application
• Apply a crosspoint change to route the desired Kaleido-X logical source to the video
monitor whose source assignment you wish to change on the monitor wall, in the same
way you would do for any router controlled by the device or application you have.
The video from the first video level assignment within the selected logical source
appears in the video window.
When the current layout is reloaded, either of the following two situations may apply.
• No logical source: If there was no logical source associated with the monitor, then
the Kaleido-X will remember the new source assignment.
• Not a monitor wall destination: If the monitor was not already configured as a
monitor wall destination, then the layout will be reloaded in its initial state, as it
was configured in XEdit.
Viewing Assignment Information
To view the current assignment information for a video monitor
• Right-click the video monitor, and then point to Info on the menu.