Renesas SH7641 - Manual (Page 84)

Section 2 CPU
Rev. 4.00 Sep. 14, 2005 Page 34 of 982
REJ09B0023-0400
SSR
31 0
Saved status register (SSR)
SPC
31 0
Saved program counter (SPC)
GBR
31 0
Global base register
VBR
31 0
Vector base register
RS
31 0
Repeat start register
RE
31 0
Repeat end register
ME MS
31 16 15 0
Modulo register MOD
ME: Modulo end address, MS: Modulo start address
Saved status register (SSR)
Stores current SR value at time of exception to indicate processor status when returning to instruction stream from
exception handler.
Saved program counter (SPC)
Stores current PC value at time of exception to indicate return address on completion of exception handling.
Global base register (GBR)
Stores base address of GBR-indirect addressing mode. The GBR-indirect addressing mode is used for data transfer
and logical operations on the on-chip peripheral module register area.
Vector base register (VBR)
Stores base address of exception vector area.
Repeat start register (RS)
Used in DSP mode only. Indicates start address of repeat loop.
Repeat end register (RE)
Used in DSP mode only. Indicates address of repeat loop end.
Modulo register (MOD)
Used in DSP mode only.
MD[31:16]: ME: Modulo end address, MD[15:0]: Modulo start address.
In X/Y operand address generation, the CPU compares the address with ME, and if it is the same, loads MS in either
the X or Y operand address register (depending on bits DMX and DMY in the SR register).
Figure 2.5 Control Registers (2)