Renesas SH7641 User Manual
Page 45
Rev. 4.00 Sep. 14, 2005 Page xlv of l
Table 7.8
LRU and Way Replacement (when W2LOCK = 1 and W3LOCK = 1)............... 186
Section 8 X/Y Memory
Table 8.1
X/Y Memory Specifications ................................................................................. 193
Section 9 Exception Handling
Table 9.1
Exception Event Vectors....................................................................................... 204
Table 9.2
Type of Reset........................................................................................................ 206
Table 9.3
Instruction Positions and Restriction Types.......................................................... 210
Table 9.4
SPC Value When a Re-Execution Type Exception Occurs in Repeat Control ..... 213
Table 9.5
Exception Acceptance in the Repeat Loop ........................................................... 214
Table 9.6
Instruction Where a Specific Exception Occurs
When a Memory Access Exception Occurs in Repeat Control............................. 215
Section 10 Interrupt Controller (INTC)
Table 10.1
Pin Configuration.................................................................................................. 221
Table 10.2
Interrupt Sources and IPRB to IPRJ ..................................................................... 224
Table 10.3
Correspondence between Interrupt Sources and IMR0 to IMR10 ........................ 230
Table 10.4
Correspondence between Interrupt Sources and IMCR0 to IMCR10................... 232
Table 10.5
Interrupt Exception Handling Sources and Priority .............................................. 236
Section 11 User Break Controller (UBC)
Table 11.1
Specifying Break Address Register ...................................................................... 246
Table 11.2
Specifying Break Data Register............................................................................ 248
Table 11.3
Data Access Cycle Addresses and Operand Size Comparison Conditions........... 258
Section 12 Bus State Controller (BSC)
Table 12.1
Pin Configuration.................................................................................................. 272
Table 12.2
Address Space Map 1 (CMNCR.MAP = 0).......................................................... 275
Table 12.3
Address Space Map 2 (CMNCR.MAP = 1).......................................................... 276
Table 12.4
Correspondence between External Pin MD3 and Bus Width of Area 0 ............... 277
Table 12.5
32-Bit External Device Access and Data Alignment ............................................ 321
Table 12.6
16-Bit External Device Access and Data Alignment ............................................ 322
Table 12.7
8-Bit External Device Access and Data Alignment .............................................. 323
Table 12.8
Relationship between BSZ1, 0, A2/3ROW1, 0, and
Address
Multiplex
Output (1)-1............................................................................ 340
Table 12.8
Relationship between BSZ1, 0, A2/3ROW1, 0, and
Address
Multiplex
Output (1)-2............................................................................ 341
Table 12.9
Relationship between BSZ1, 0, A2/3ROW1, 0, and
Address
Multiplex
Output (2)-1............................................................................ 342
Table 12.9
Relationship between BSZ1, 0, A2/3ROW1, 0, and
Address
Multiplex
Output (2)-2............................................................................ 343