MTS Multipurpose Elite - Manual (Page 580)

Show Condition lets you show or hide the test-run displays, depending on the condition of the variable
expression. For example, you could set up a condition to check the variable containing the specimen type
for a Set Variable test-run display to make visible the diameter only when the specimen type is round, but
hidden for a rectangular specimen. Likewise, you can use two more Set Variable test-run displays for
width and length to be visible if the specimen type is rectangular but hidden when the specimen type is
round.
Create a Digital IO Test-Run Display
To create a Digital IO test-run display:
1. Click the Test-Run Display tab > Designer tab > Toolbox panel.
2. In the Interactive section, click the Digital IO tool and drag it to the desired location in the Designer
tab workspace.
3. In the Properties panel, click the Signal ellipsis button.
Select a Signal Window
4. Select either a Digital Input or Digital Output signal to monitor and click OK.
5. (Optional) Adjust the Font Size as needed.
6. Repeat these steps for each digital IO signal you want to monitor.
For More Information
Concept
About Digital IO Displays (p. 578)
Reference
Digital IO Properties (p. 578)
Example Digital IO Workflow (p. 581)
580 | MTS TestSuite
Test-Run Displays