MTS Multipurpose Elite - Manual (Page 399)

Description Item
• One Time—(Default) Performs one check of the
inputs. The action is triggered only if the conditions
are detected by the one-time check.
• Continuous—Performs a continuous check of
the inputs. The action is triggered if any of the
checks detects that the conditions are met.
Specifies when to perform the associated action. Trigger When
• Any Digital Event Occurs—(Default) Any one
of the monitored events can trigger the action if
the signal conditions are met.
• All Digital Events Occur—All monitored signals
must reach their signal conditions for the activity
trigger to occur.
Specify the action to take. The available actions are
controller- and test resource-dependent. Action
Required.
Indicates whether or not to log events from the Digital
Input activity and the level at which to log. Available
options are: Log
• None
• Informational
• Warning
• Error
Selects the specific digital inputs for the activity to
monitor. To add or delete inputs from the list, click
the plus or minus signs. Digital Inputs
Required.
Controller Actions
You can set the following actions in activities that set controller actions. The actions depend on the type
of controller and the defined test resources. Additionally, any controller actions (such as Interlock, C-Stop
Interlock, or Program Stop Interlock) will appear in the Application Log under the category ControllerLog.
Controller Action Descriptions
Description Action Selected
MTS TestSuite | 399
Test Activities