MTS Multipurpose Elite - Manual (Page 412)

To purchase one of these licenses and begin using this test activity, contact your MTS sales engineer.
State Change Detection Activity Properties
State Change Detection Activity Properties
Description Item
The procedure is controlling the machine and playing
out a waveform. This state is sometimes referred to
as “Run” in log messages. Running
The procedure and controller actuators are fully
stopped. This state is sometimes referred to as “Stop”
in log messages. Stopped
The state in which the test procedure suspends the
activity on the controller. The actuator is not moving,
but the test can be continued by clicking Run. Hold
The transition state between Stopped and Running. Starting
The transition state between Running or Holding and
Stopped. Stopping
The transition state between Running and Holding. Holding
The transition state between Hold and Running. Resuming
412 | MTS TestSuite
Test Activities