MTS Multipurpose Elite - Manual (Page 507)

Group variable mapping occurs in the Procedure definition part of the test. If more than one type of group
is available, the Monitor for Change box of the Hysteresis Chart Properties contains a drop-down selection
button. The default value is Cycle. Other variables listed in the Monitor for Change box are variables
specified in the Save Variables box of the Map Variables window.
You can select a cycle by number or by using a variable. On the chart, the zero-value reference lines are
slightly darker than the other grid lines to provide a visual orientation to your data.
You can include an image of a Hysteresis Chart in reports.
Hysteresis Chart Properties
Hysteresis Chart Properties Panel
Display Name
This is the name that is shown for the object in the application. It is a required property so the box cannot
be empty. The default is the type of the chart and the number indicating how many are on the Display tab,
such as Cycle Statistics Table 1. You can also click in the box and type a new name.
Note:
The Display Name is only used in the event of validation errors.
Visibility Panel
Visibility Panel
MTS TestSuite | 507
Test-Run Displays