MTS Multipurpose Elite - Manual (Page 368)

Description Item
state shows distance traveled, and the target state
shows target distance.
Disabling this check box causes the current state and
target state to show time values.
Selecting either Fixed or Transient for Visibility
enables the Show Distance Traveled check box.
Sets the speed the vehicle runs at during the test.
Click the toggle button to specify a numeric value or
a variable. Progress Table >
Vehicle Speed
The Show Distance Traveled check box must be
selected to enable the Vehicle Speed box.
Specifies the directory in which the file is saved. File
Displays the Time History Summary window for the
selected time history file. Show Summary
Reloads the sequence file if it was changed outside
of MPE. Update from File
Selects the number of passes the Road Surface file
play outs each time the process runs. Total Passes
If selected, the activity reads the current command
value on each channel when the activity runs. These Relative Time
Signal
commands are added to each point in the time history
as it is read from its file and the modified command
is played out. With this feature you can preload a
channel and then play out the time history relative to
that pre-loaded value. If not checked, the time history
is played out as stored in the disk file.
When enabled and Relative Time Signal is not
selected, the activity starts by ramping to the first Drive Has An
Offset
command point in the time history, and ends at the
last command point in the time history, without
returning to zero.
When enabled and Relative Time Signal is selected,
the activity starts by ramping to the first command
point in the time history, and ends by returning to the
starting point after the last specified pass is
completed.
Note:
The command signal does not return to zero
(or to the starting point in relative mode)
368 | MTS TestSuite
Test Activities