MTS Multipurpose Elite - Manual (Page 487)

• The scope configuration settings are not saved with a test. The configuration settings are only good
for the current application session.
Buttons available on the scope
A tab contains the scope for general system operation. The scope shows live signal data from the test
station.
Scope Buttons
Description Item
Shows live data on the scope. Run Scope
Stops showing live data on the scope. This button becomes active when
the scope begins to run. Stop Scope
Creates a tab for an additional scope. Launch Another
Scope
Click Launch Another Scope to remove the additional scope you create.
This button does not close the original scope. To close the original scope,
click Display > Scope. Close Scope
Using the scope toolbar
To display the scope toolbar, click the arrow on the lower left side of the scope. You can use this toolbar
to perform many commonly-used scope actions, such as toggle Point Picking, toggle zooming, or add a
trace.
Scope Toolbar Buttons
Description Name Button
Shows or hides the scope toolbar. Show/Hide
Toolbar
Shows live data on the scope. Start the
Scope
Stops showing live data on the scope. This button becomes active when
the scope begins to run. Stop the
Scope
Opens the Select Signal window. Select an item from the list to add a
new trace to the scope. Add a
trace
When Point Picking is enabled, you can click traces in the scope to mark
individual data points. Toggle
Point
Picking
MTS TestSuite | 487
Test-Run Displays