MTS Multipurpose Elite - Manual (Page 420)

Change Detection activity to determine if the change has occurred before continuing with subsequent
activities. For example, if you use the Set Control Event activity to trigger a Program Hold action, you
can use the State Change Detection activity to determine if the controller is in a hold state before continuing.
Set Control Event Activity Properties
Set Control Event Activity Properties
Description Item
Specifies the action to occur when a condition is
triggered, which is specified by another activity such
as an If-Else Condition. Action
Specifies the type of optional message to be
generated. Log as:
Specifies the optional message to be generated. Message
Controller Actions
You can set the following actions in activities that set controller actions. The actions depend on the type
of controller and the defined test resources. Additionally, any controller actions (such as Interlock, C-Stop
Interlock, or Program Stop Interlock) will appear in the Application Log under the category ControllerLog.
Controller Action Descriptions
Description Action Selected
No controller action is taken. The test continues to run. No Action
A message is generated and shown to the operator. The test continues
to run. Indicate
Testing stops. Power is removed from the station. Station Power Off
420 | MTS TestSuite
Test Activities