Adobe After Effects CS3 - Manual (Page 463)

AFTER EFFECTS CS3
User Guide
458
The Add Grain and Match Grain effects let you reproduce these subtle changes in grain patterns across areas of an
image or a sequence by using the Shadows, Midtones, Highlights, and Midpoint controls in the Application controls
group. These controls let you define how much grain is added to each tonal area and also to each channel in the
image. For example, you can add more grain to overexposed areas of the blue channel to give an image of sky a
grainier look.
You can use the Application controls group for the Add Grain or Match Grain effect to do the following:
• To define how much grain is added to each tonal area in an image, adjust the Shadows, Midtones, and Highlights
values.
• To define the midpoint of the image’s tonal range for grain application purposes, adjust the Midpoint slider. By
default, this slider is centered at 0.5, which represents the middle of the range of pixel values—127 for 8-bpc images
and 16384 for 16-bpc images.
• For even finer control, use the Channel Balance controls to adjust the grain in the shadow, midtone, and highlight
areas independently for each channel.
Animating added or matched grain
By default, the grain or noise generated by the Add Grain and Match Grain effects moves at the same speed as the
source material to accurately simulate realistic noise. Slowing down the noise processes may be useful for aesthetic
effect or to keep the added noise from buzzing and drawing attention to itself. These effects have an internal
randomizer that changes the positions of the noise pixels between frames. But you can also change the appearance
of the noise between layers on the same frame while keeping every other parameter constant.
You can use the Animation controls group for the Add Grain or Match Grain effect to do the following:
• To determine the frame rate of the added grain, as a multiple of the destination frame rate, adjust the Animation
Speed value in the Animation controls group in the Effect Controls panel. At the default 1, the noise moves at the
same rate as the frames. At zero, the noise is stationary over time.
• To use interpolation to create smooth transitions between the generated noise frames, select Animate Smoothly.
This control matters only if Animation Speed is less than 1.
• To change the appearance of the noise between layers on the same frame, adjust the Random Seed value. Each
Random Seed value represents one of 100 possible variations in the appearance; changing the value doesn’t make
the results more or less random.
Blending and adjusting the color of added or matched grain
You can adjust the color, saturation, and blending behavior of the grain generated by the Add Grain or Match Grain
effect.
Several factors can affect the apparent color of the grain that these effects generate, including the following:
• The color value of the underlying pixel in the source image.
• The Saturation value of the noise.
• The Tint Color and Tint Amount values, if you have modified these from the defaults.
• The Blending Mode value in the Application controls group.
• The amount of noise applied, if any, to each channel individually using the Channel Intensities controls group.