Adobe After Effects CS3 - Manual (Page 101)

AFTER EFFECTS CS3
User Guide
96
The Basic tab in the Camera Raw dialog box has three controls for correcting a color cast in an image:
White Balance Camera Raw applies the white balance setting and changes the Temperature and Tint properties in
the Basic tab accordingly. Use these controls to fine-tune the color balance.
• As Shot Uses the camera’s white balance settings, if they are available.
• Auto Calculates the white balance based on the image data.
Note: If Camera Raw doesn’t recognize the white balance setting of a camera, choosing As Shot is the same as choosing Auto.
Temperature Sets the white balance to a custom color temperature. Decrease Temperature to correct a photo taken
with a lower color temperature of light; the Camera Raw plug-in makes the image colors bluer to compensate for the
lower color temperature (yellowish) of the ambient light. Conversely, increase Temperature to correct a photo taken
with a higher color temperature of light; the image colors become warmer (yellowish) to compensate for the higher
color temperature (bluish) of the ambient light.
Note: The range and units for the Temperature and Tint controls are different when you are adjusting a non-camera raw
image, such as a TIFF or JPEG image. For instance, Camera Raw provides a true-temperature adjustment slider for raw
files from 2,000 Kelvin to 50,000 Kelvin. For JPEG or TIFF files, Camera Raw attempts to approximate a different color
temperature or white balance, but because the original value was already used to alter the pixel data in the file, Camera
Raw does not provide the true Kelvin temperature scale. In these instances an approximate scale of -100 to 100 is used
in place of the temperature scale.
Correcting the white balance
A. Moving the Temperature slider to the right corrects a photo taken with a higher color temperature of light B. Moving the Temperature slider
to the left corrects a photo taken with a lower color temperature of light
C. Photo after color temperature adjustment
Tint Sets the white balance to compensate for a green or magenta tint. Decrease Tint to add green to the image;
increase Tint to add magenta.
To adjust the white balance quickly, select the White Balance tool , and then click an area in the preview image
that should be a neutral gray or white. The Temperature and Tint properties adjust to make the selected color exactly
neutral (if possible). If you’re clicking whites, choose a highlight area that contains significant white detail rather than a
specular highlight. You can double-click the White Balance button to reset White Balance to As Shot.
A
C
B