Clear-Com Eclipse-Omega - Manual (Page 78)

Clear-Com
Eclipse Configuration Software Instruction Manual
3 - 2 4
Key Operation Setup
This tab controls the incoming audio signalization (tally) key color of
keys and rotary encoders on panels connected to Eclipse matrices.
Figure 3-29: Key Operation Tab
Tally Settings
Enable the incoming Tally flash color to be changed (default is Red).
Settings are:
Red
Tally flash color is Red.
Green
Tally flash color is Green (only for 4000 Series II Panels, ICS
1008/1016 panels and I-stations).
Panels generate In-Use Tallies on talk out AND receive
The called panel will generate an In-Use tally signal which will be
displayed on all other panels which have a label to the called panel.
The default for the option is unchecked.
Panels continue to receive incoming calling tally AFTER reply
The receiving panel will continue to receive and display the incoming
call tally after the incoming call has been answered using the Reply
key. The following key signalizations are only displayed by i-Station
and V-Series panels.
If Tally Settings is set to Red then i-Station and V-Series panels flash
dim red at 4 Hz after reply and then release of the talk key if this option
is checked.