Clear-Com Eclipse-Omega - Manual (Page 215)

Clear-Com
Eclipse Configuration Software Instruction Manual 5 - 1 0 5
One Digit Codes
If One Digit Codes is set to true the selector codes are limited to one
digit—0 though 9—plus the quick keys—pound (#) and asterisk (*).
These codes are easier to remember and dial; however, they also
have the following limitations:
• Only ten codes are available
• Control codes are not recognized
• The pound and asterisk keys can only be assigned a single digit
code
• The system will no longer recognize the "0" form,
which will deactivate any established individual path. This means
if multiple codes, has been enabled a previously established path
cannot be deactivated.
First Code Only
If the First Code Only is set to true the DTMF tone detection will be
disabled after the first valid code has been received. DTMF decoding
can also be disabled by entering the disable DTMF decoding control
code (92), described in the Control Codes section.
Certain circumstances may encourage the disabling of DTMF-tone
detection. During normal operation, DTMF tones in the port’s audio
input are decoded at all times. However, certain audio program
sources— such as telephone company commercials—may contain
DTMF tones that are not intended to be interpreted as selector codes,
and can inadvertently reroute the audio path. Certain voices or musical
instruments can also fool the DTMF tone detection circuitry into
detecting false DTMF tones.
By disabling DTMF-tone detection after the program feed has been set
up, the paths will not be accidentally rerouted. To re-enable tone
decoding, hang up and call back again.
Quick Codes
These menus define the Touch-Tone keypad’s asterisk (*) and pound
(#) keys as quick keys through the use of quick codes. If a two-digit
pair (corresponding to one of the valid selector codes or control codes)
is selected from the menus for the asterisk or the pound, the DTMF
port will translate the asterisks or pound’s DTMF tone into that
two-digit code. For example, if the asterisk key is supposed to clear all
paths, select [00] from the [*] menu. If the [One Digit Codes] box is
checked, the quick keys cannot be assigned control codes.