Clear-Com Eclipse-Omega - Manual (Page 40)

Clear-Com
Eclipse Configuration Software Instruction Manual
1 - 6
Figure 1-3: An Eclipse Configuration
Basic Setup Steps
The basic steps for setting up an Eclipse matrix system are:
1. Ensure that there is a working connection between the ECS PC and
the matrix (see chapter 3 for information on selecting the connection
type and setting ethernet addresses).
2. Click on the ‘System’ menu to open the systemscreen and right click
over the systems pane to open the ‘Add Matrix Frame’ option.
3. Click on the ‘Add Matrix Frame’ to add a new matrix. Click on the
highlighted ‘Please choose a matrix type’ button to open the matrix
type menu and select the required matrix type.
4. Click on the ‘New Matrix Frame’ window on the new matrix icon and
enter the name of the new matrix.
5. Click over the ‘Matrix IP Address’ window of the new matrix icon and
enter the IP address of the new matrix.
category-5 cable
talk pathway
listen pathway
category-5 cable
talk pathway
listen pathway
category-5 cable
talk pathway
listen pathway
category-5 cable
talk pathway
listen pathway
Eclipse Matrix
The matrix system forms a star configuration.
Audio travels through the central matrix and
out to the connected panels. The panels
do not connect to each other, but to the matrix.
Label appears in display
of intercom
Cat-5 cable connects to rear-panel
RJ-45 connector, or “port”
Label appears in display
of intercom
Label appears in display
of intercom
Label appears in display
of intercom
Cat-5 cable connects to rear-panel
RJ-45 connector, or “port”
Cat-5 cable connects to rear-panel
RJ-45 connector, or “port”
Cat-5 cable connects to rear-panel
RJ-45 connector, or “port”