Clear-Com Eclipse-Omega - Manual (Page 341)

Clear-Com
Eclipse Configuration Software Instruction Manual 8 - 1 3
Figure 8-11: Setting IFB Dim on Crosspoint
The level settings from +12dB to -30dB represent the levels set for
audio through the crosspoint and Mute will stop all audio through the
crosspoint. Below this are the IFB dim levels from 0dB to -30dB and
Mute (IFB completely interrupts audio feed).
Setting Up IFBs in Imported Configurations
When a ECS 4.2 map is imported the IFB control information V-Series
panels is lost due to changes in the way the configuration data is
organized. In order to restore the IFBs and restore the control
information the following steps should be carried out.
1. Open Panel Programming from the Configuration menu.
2. Select the V-Series panel that the IFB control was originally
attached to.
3. Open the audio mixer.
4. Use the audio mixer to set the IFB dimming for EXT1 and EXT2
crosspoints as required. This action will create Panel IFB relays
IFB1 and IFB2 for that panel.
5. Close the audio mixer.