Clear-Com Eclipse-Omega - Manual (Page 111)

Clear-Com
Eclipse Configuration Software Instruction Manual 5 - 1
ECLIPSE SETUP
The ECS menus in the left hand pane are used to configure the Matrix
Hardware ports, IP interfaces, Panels, Conferences, Local Advanced,
Controls, Sort Groups, Routes, Speed Dials, Attachments, Key
Groups, Beltpacks and Beltpack Roles. Also configuring GPI and
Relay modules in the Hardware is covered in this section.
Figure 5-1: Eclipse Main Menu
Various menu items may be highlighted in amber to indicate possible
configuration problems.
The ‘System’ menu may be highlighted if:
• There is an open project, but not an open configuration.
• There is an open configuration but the matrix type is not set.
• There are multiple frames in the system but the fibre ring is judged
to be incorrect.
The ‘Cards and Ports’ link may be highlighted if:
• There are no ports configured for a particular frame
The ‘IP Devices’ link may be highlighted if:
• There are IP cards which do not have ports
The ‘Beltpacks’ link may be highlighted if:
• There are antennas but no beltpacks
The ‘Panels’ link may be highlighted if:
• There are key groups which do not have memberse
• There are panels configured but no keys
5