Clear-Com Eclipse-Omega - Manual (Page 363)

Clear-Com
Eclipse Configuration Software Instruction Manual 1 0 - 1 3
Figure 10-16: Remote Party Line
5. Select the members of the party line from the ‘Available’ pane and
click on the ‘>’ button to transfer them to the ‘Attached’ pane. They
are now members of the party line. To remove members from the
party line select them in the ‘Attached’ pane and click on the ‘<‘ to
transfer them back to the ‘Available’ pane.
6. Click on the ‘Apply Changes to Frame’ button to download the new
map to the frame immediately or close the Party Line dialogue if
other changes are to be made.
Note: All the possible members of a party line are displayed in
the ‘Available’ pane. If more than one frame configuration is
open all the labels from that configuration are listed in the
‘Available’ pane and are not specifically listed under a
remote tab. The tabs on the bottom of the ‘Available’ and
‘Attached’ panes allow selection of devices by configuration
to determine which labels are remote to the local frame.
REMOTE 2-WAY RADIO
If a 2-way radio system if connected via a FOR-22, the 2-Way Radio
can operate over an intelligently linked system. To configure a remote
2-way radio the following steps should be followed:
• Create a control, attach the relay for the FOR-22, and set the control
as a secondary action on the FOR-22.
• Apply and reset the frame.
• Switch configurations, and open the panel programming screen.