Clear-Com Eclipse-Omega - Manual (Page 137)

Clear-Com
Eclipse Configuration Software Instruction Manual 5 - 2 7
Enable Passcodes
This enables the use of passcodes that are set up using the DTMF
Settings tab under ‘Matrix Frame Preferences’. Up to eight DTMF
passcodes can be set up for a system and each passcode can be
enabled for a port via a drop-down menu.
When enabled incoming callers must enter a 4 digit passcode before
being allowed access.
First Code Only
If this is enabled DTMF tone detection will be disabled after the first
valid DTMF code has been received. Default is disabled.
Note: Only on TEL-14.
Multiple Codes (Accumulate)
This field controls whether only one DTMF selector code can be used
(disabled) or whether multiple DTMF selector codes can be used. The
default setting is disabled.
When enabled this allows the incoming caller to make multiple routes
by dialling multiple codes.
One Digit Codes
If this is set enabled DTMF selector codes are limited to a single digit
or the hash (#) and asterisk (*) characters. The default setting is
disabled.
Applies to:
Direct, CCI-22, FOR-22 and TEL-14 interfaces.
LOGIC INPUTS
The Logic Inputs are used in relation to the Miscellaneous GPI
connections on panels that are fitted with local option cards and
V-Series panels.
The logic inputs are also associated with PTT function on headset 1
and headset 2 on V-Series panels where the headset is either an
XLR-7 type headset connected to the front panel or a headset
connected to the auxiliary audio connector. In the case of V-Series
panels headset 1 PTT 1 or headset 2 PTT 1 active will have the same
effect as Logic 1 active. Headset 1 PTT 2 or headset 2 PTT 2 active
will have the same effect as Logic 2 active.
The PTT actions for XLR-4 and XLR-5 headsets connected to a
V-Series panel are determined by the ‘Headset PTT Function’ setting.
The following actions are available for both Logic Input 1 and Logic
Input 2: