Clear-Com Eclipse-Omega - Manual (Page 163)

Clear-Com
Eclipse Configuration Software Instruction Manual 5 - 5 3
Description
An optional description for the port of up to 255 characters long.
E-QUE Splitter
This action automatically adds an E-Que card with two splitter ports
configured. Each splitter can support up to five antennae and each
antenna provides six beltpack ports. The hardware table shows ten
antennae with the first beltpack port number for each antenna rather
than the E-Que port number. Therefore the first antenna is shown as
port 1 (the first beltpack port) and the second antenna is shown as port
7 (previous first port number plus six), since beltpack ports 1-6 are on
the first antenna. This is repeated for successive antennae.
Figure 5-24: Splitter Ports
Port Function
This is always set to “Antenna”.
Talk Label
This is used to identify the E-Que antenna port location but is not used
to assign talk paths.
Listen Label
This is used to identify the E-Que antenna port location but is not used
to assign listen paths.
Description
An optional description for the port of up to 255 characters long.