Input volume, Main volume off limit, Output volume – Clear-Com Eclipse-Omega User Manual
Page 136: Sidetone gain, Applies to, Dtmf settings, Access prompt, Assign dtmf codes, Input volume -26, Main volume off limit -26
Clear-Com
Eclipse Configuration Software Instruction Manual
5 - 2 6
Input Volume
Allows the input volume level to be set. To set the input volume select
the volume box to display the volume adjust slider and use the mouse
to set the required volume from +15 dB to -45dB (or type in the value).
The default is 0dB.
Main Volume Off Limit
Sets the minimum limit for the main audio output so that the volume
cannot be turned completely off.
Note: Only available on V-Series panels.
Output Volume
Allows the output volume level to be set. To set the output volume
select the volume box to display the volume adjust slider and use the
mouse to set the required volume from +15 dB to -45dB (or type in the
value). The default is 0dB.
Sidetone Gain
Sets the sidetone gain in dB for the panel. The default is 0dB.
Note: Not available for V-Series, ICS 102, PD4224E, CCI-22, ICS
1008, ICS 1016, ICS 52, ICS 62, ICS 92E, Concert, PD4212E,
PD4215E, PD4222E, PD4226E panels, AES Mono, Panel Aux,
Trunk, Direct and FOR-22 interfaces.
Applies to:
i-Station.
DTMF SETTINGS
These settings are used to configure the TEL-14 or external telephone
hybrid for incoming calls and control the access to the system by the
external caller. The setups for outgoing calls are configured on the
MVX-16A card which controls the outgoing DTMF on TEL-14
interfaces (except for ICS-2003 which can generate DTMF directly).
Access Prompt
Controls whether the port sends DTMF access prompt tones and may
be enabled or disabled. This allows the incoming caller to receive
access prompts. The default is enabled.
Assign DTMF Codes
Assigns a DTMF selector code to a specific audio path. This allows
the incoming caller to make various preselected links within the matrix
by entering a specific code.
Audio level sent into the
matrix (matrix input volume)
Audio level sent from the
matrix (matrix output volume)
Used in conjunction
with TEL-14 modules.
The TEL-14 has a
number of user
features.
DDI - incoming caller
can route themselves to
listen to studio output
using DTMF codes.
Passcodes to stop
unwanted callers.