Clear-Com Eclipse-Omega - Manual (Page 217)

Clear-Com
Eclipse Configuration Software Instruction Manual 5 - 1 0 7
Figure 5-35: DTMF Assignment Screen
2. Select the desired destination label from the palette of available
destinations, at the bottom of the screen.
3. Find the desired code in the DTMF Codes column.
4. The columns to the right of the DTMF Codes column allow assigning
as many as three talk labels and one listen label for each key. Click
in the column for the desired type of label for the desired code: Talk
1, Talk 2, Talk 3, or Listen. The selected label will appear in the
desired cell. If this cell has already been assigned a label, the new
label will displace the old one.
5. Download the new configuration to the Frame with an Apply Label
Changes download.
Note: Although above describes a single route multiple routes
can be attached to a control.
One Digit Code Setup
Figure 5-36: Code Setup
To assign the one-digit selector codes (numbered "0" through "9"), set
the [One Digit Codes] field in the Advanced Settings screen for a
telephone interface to true.