Cable length, Description, Engineer comments – Clear-Com Eclipse-Omega User Manual
Page 166: Listen label, Talk label, Antennas role map, Cable length -56, Description -56, Engineer comments -56, Listen label -56
Clear-Com
Eclipse Configuration Software Instruction Manual
5 - 5 6
Select the card port to be configured and open the ‘Basic Settings’
option under ‘Advanced Settings - Beltpack Antenna’ to set up the port
parameters.
Cable Length
To set the cable length between the card and the antenna select the
‘Cable Length’ option and open the drop-down slider. User the mouse
to adjust the cable length setting from 0 - 129 meters to 2860 - 2989
meters. The length set will be displayed next to the option.
Description
Enter an optional description for the antenna such as position or
function.
Engineer Comments
A scratchpad for engineers to record any relevant information about
the port or antenna.
Listen Label
Listen labels for antennas are only used for diagnostics purposes
(antenna/role correlation).
Talk Label
Talk labels for antennas are only used for diagnostics purposes
(antenna/role correlation).
To configure an E-Que card for Splitters select the card on the
hardware list to display the configuration screen. In this case ten
antennas will be displayed corresponding to the two splitters that can
be connected to an E-Que card with each splitter supporting up to five
antennas.
ANTENNAS ROLE MAP
Select the ‘Antenna Role Map’ link at the botom of the ‘Advanced
Settings’ pane to display the status of the antennas and roles currently
configured.