Clear-Com Eclipse-Omega - Manual (Page 122)

Clear-Com
Eclipse Configuration Software Instruction Manual
5 - 1 2
Note that if the FOR-22 is to be used as a 2-Way Radio from
remote systems, the FOR-22 relay should be added as a
secondary action in Advanced Settings.
When the FOR-22 is in 2-Way Radio mode the rack has control
of the relay and will automatically fire it.
• 4-Wire —When the port is wired directly to an external device.
Normally 4-wire functions are only audio connections and do not
use call signals. By default, when a 4-wire port is connected to an
FOR-22 4-Wire Audio Interface, a call signal sent to the port from
the Eclipse System activates the FOR-22 channel’s relay.
Alternatively, this relay can be activated by attaching the relay
name to a control label configured in the Control Manager.
When the FOR-22 is in 4-Wire mode the relay will not
automatically fire. To make the relay fire when a talk path to the
FOR-22 is created a control must be created and added as a
secondary action in the Advanced Settings for the FOR-22.
When enabled in Party Line mode the FOR-22 allows panels to
listen to all commands to/from the interface.
• i-Station - The port is configured to drive a i-Station with 30
pushbuttons.
• ICS-1008 - The port is configured to drive an ICS-1008 panel with 16
pushbuttons.
• ICS-1016 - The port is configured to drive an ICS-1016 panel with 32
pushbuttons.
• ICS-102 - The port is configured to drive an ICS-102 panel with 10
selectors allowing up to 10 connections.
• ICS-2003 - The port is configured to drive an ICS-2003 panel with two
pages of 12 selectors allowing up to 24 connections.
• ICS-52 - The port is configured to drive an ICS-52 panel with 5
selectors allowing up to 5 connections.
• ICS-62 - The port is configured to drive an ICS-62 panel with 6
selectors allowing up to 6 connections.
• ICS-92 - The port is configured to drive an ICS-92 panel with 9
selectors allowing up to 9 connections.
• Panel Aux - The port is configured for an AES-6-CX interface
providing a binaural connection to a panel supporting split-ear
operation. Currently only the following panels are supported for this
mode or operation: PD4224E, PD4215E, PD4226E, PD4294E,
PD4212E and PD4222E. This type of port must be configured as
part of a pair of ports to provide a binaural connection to the panel.
The first or master port of the pair is configured for the attached
panel in the normal way and the Aux Port is the second port
configured under Basic Settings.