Clear-Com Eclipse-Omega - Manual (Page 75)

Clear-Com
Eclipse Configuration Software Instruction Manual 3 - 2 1
There are eight DTMF access codes. If a value is assigned to any of
them, it will be available for recognition by any MVX-16A port in the
Eclipse System. The local configuration of each TEL-14 that is
connected to a MVX-16A port will include setting that port to recognize
any, all, or none of these DTMF access codes. If any MVX-16A port
has been configured to recognize one or more of these DTMF access
codes, that port will allow system access to any caller who correctly
enters any one of the recognized access codes.
Access codes can be only numeric characters and must be four digits
long—no more and no less. ECS will not allow a password field
containing fewer than four characters, and will only accept numerals.
Note: For DTMF decoding to operate DTMF Daughter boards are
required on each MVX Card. Since v1.2 this is a standard fit.
Contact a sales representative if the MVX cards do not have
the DTMF daughter boards fitted.
Note: For Eclipse Pico only ports 17-32 are fitted with DTMF
cards.
Figure 3-25: System Passcodes
Panel Menu Access Code
The menus on V-Series main panels and ICS-2003 panels can be
PIN-code protected. Enter the PIN code here. When users attempt to
access PIN-protected menus they will have to enter this code.
The PIN protected menus on V-Series main panels are:
• Sys Config Access
• Local Pref Menu access