Clear-Com Eclipse-Omega - Manual (Page 221)

Clear-Com
Eclipse Configuration Software Instruction Manual 5 - 1 1 1
BELTPACKS
Selecting ‘Beltpacks’ from the ECS setup menu displays the beltpack
configuration editor which will allow beltpacks to be added and
configured. Before a beltpack will work, it must be registered to the
system. To do this:
1. In ‘Matrix Frame Preferences’ set the correct DECT system ID and
Frequency.
2. Configure the COM port to use for the beltpacks.
3. Open the Beltpacks screen, and enter a beltpack.
4. Connect the required beltpack on the COM port.
5. Press the "Register connected Beltpack to this system" button.
Figure 5-40: Beltpack Registration Setup
Click on the ‘Register Beltpacks’ button to register a beltpack. A list of
instructions to register a beltpack will be displayed.