Clear-Com Eclipse-Omega - Manual (Page 142)

Clear-Com
Eclipse Configuration Software Instruction Manual
5 - 3 2
Page Override
The panel main volume audio can be overridden by paging audio from
another panel. The default setting is disabled. For Page Override to
operate this must be set to True on any destination panel where the
local main volume setting may need to be overridden by a calling
panel. This is used in conjunction with Page Volume.
Note: Only available on ICS-2003E, ICS-102, PD4224E, I-Station,
ICS-1008, ICS-1016, ICS-52E, ICS-62, ICS-92E, PD4212E,
PD4215E, PD4226E, PD4222E, Concert, V-Series panels.
Page Volume
Allows the volume of the Page Override audio to be set. To set the
Page Override volume select the Page Volume option box to display
the volume adjust slider and use the mouse to set the required level.
The level range is from 0 to 10. The default volume setting is 0.
This is used in conjunction with Page Override.
Note: Only available on ICS-2003E, ICS-102, PD4224E, I-Station,
ICS-1008, ICS-1016, ICS-52E, ICS-62, ICS-92E, PD4212E,
PD4215E, PD4226E, PD4222E, Concert, V-Series panels.
Remote Line Release
Allows the panel to release the selected telephone line which may be
held on by the incoming caller anywhere in the system. The default is
disabled.
Note: Not available on Concert panels.
Screen Saver Timer
The screen saver timer facility sets the length of time a panel is
inactive elapse before the screen saver is displayed. The screen
saver is used to prevent the display being damaged by being left for
long periods with the same display. The time may be set to any value
between 1 and 60 minutes. It cannot be disabled.
If the dim timer is set to a value other than “Always Dim” the screen
saver timer will only start after the screen has dimmed. For example if
the dim timer is set to 1 minute and the screen saver timer is set to 1
minute the screen saver will start after 2 minutes. If the dim timer is set
to “Always Dim” the screen saver inactivity timer will start immediately.
Note: Only available on V-Series panels.
Simultaneous Main and Swap
The options controls whether the current talk audio paths are
maintained or cut when the swap page is viewed. The default setting
is disabled causing the audio paths from the main page to be cut when
If a panel with Page Override
set turns their main volume
level down, an incoming
page from another panel will
reset the volume level so that
the audio can be heard.