Clear-Com Eclipse-Omega - Manual (Page 289)

Clear-Com
Eclipse Configuration Software Instruction Manual 7 - 3 7
Select the required file and click on the ‘Open’ button to load the labels
from the file. When a label load is performed all the labels on a panel
(including shift pages) and cleared before the new labels are applied.
If the type of panel being loaded is not the same as the type of panel
the label file was saved from this may result in labels being lost when
the panel is loaded.
Copy
Clicking on the ‘Copy’ button on the Panel Programming toolbar will
copy the labels of the current panel page only into the scratch pad. It
does not copy labels from expansion panels.
Paste
Clicking on the ‘Paste’ button on the Panel Programming toolbar will
paste the labels copied to the scratch pad onto the currently selected
panel. All the labels currently on the page will be lost. This allows
single pages of labels to be pasted on to the panel.
If the type of panel being pasted to is not the same as the type of panel
the labels were copied from this may result in labels being lost when
the labels are pasted onto the new panel.
Clear
Clicking on the ‘Clear’ button on the Panel Programming toolbar will
clear all the labels from the current panel including shift pages but
excluding any attached expansion panels.
Audio Mixer
Displays the audio mixer panel that allows the levels of individual
crosspoints to be adjusted interactively. This facility can only be used
with V-Series panels.
Identify Panel
Selecting the ‘Identify Panel’ button on the panel programming toolbar
will cause the panel currently being edited to flash the panel buttons or
LEDs red and display ‘IDENTIFYME’ in the bottom left display. This
facility is only available for V-Series panels; the ‘Identify Panel’ button
will be greyed out for other panel types.