Clear-Com Eclipse-Omega - Manual (Page 329)

Clear-Com
Eclipse Configuration Software Instruction Manual 8 - 1
AUDIO MIXER
INTRODUCTION TO AUDIO MIXER
The Audio Mixer facility is accessed from panel programming and is
only available for V-Series panels. The Audio Mixer allows the audio
input, output and crosspoint levels for the panel to be set by the use of
the panel controls (main and auxiliary volume controls) or via the panel
software. The audio mixer will also allow audio input levels to be
modified by means of threshold levels and compressors and for
frequency based noise reduction filters to be applied. Crosspoints
which are attached to IFB controls can also have the IFB dim levels set
by the audio mixer.
The layout of the audio mixer is determined by the panel interface
selected; for some types of interface such as the D25 connector more
options are available than with the basic RJ45 interface.
When the pointer is moved over the panel tooltips will be displayed
whenever it is over an active item such as a button on the toolbar, a
filter setting or a crosspoint. The tooltip will display the current setting
of any audio processing element.
AUDIO MIXER PANEL
The audio mixer panel is divided into three functional areas, Input,
Crosspoint and Output. Each area has separate controls that function
idependently of controls in other areas. For example the controls in
the input area will act on the input audio stream before it passes to the
crosspoints.
The audio mixer areas are shown in Figure 8-1 below.
8