Clear-Com Eclipse-Omega - Manual (Page 243)

Clear-Com
Eclipse Configuration Software Instruction Manual 6 - 1 1
IVC-32 IP SETTINGS
The ‘IP Settings’ section displays the IP setup of the IVC-card. Click
on the ‘Edit’ button to enable this section to allow changes. The fields
will change from grey text to input boxes. The external IP address and
IP port will only be enabled if the ‘External IP Address’ box is checked.
Figure 6-16: Editing IVC-32 Card Settings
IP Port
The port the panel will use to log in to the IVC-32 card. This will be the
internal IP port if the panel is on the same LAN, or the external IP port
if not.
This parameter should not normally be changed from the default value
unless all the IP panels or Concert server are also updated to use the
new port number. If this is not done the IP panels or Concert server
will not be able to communicate with the IVC-32 card. Eclipse system
administrators are advised to check with network administrators or IT
that the default port may be used without causing a conflict with any
other application on the network.
If the IP port number is changed ports 42001 and 1300 should not be
used as these ports are already used by ECS. The Eclipse system