Clear-Com Eclipse-Omega - Manual (Page 125)

Clear-Com
Eclipse Configuration Software Instruction Manual 5 - 1 5
Notes on ICS-21/22/24 Support
This section describes the difference in operation of the ICS-2x family
of panels on the Matrix plus 3 system and the Eclipse system. Please
refer to the ICS-2x Instruction Manual for operation with Matrix plus 3
system.
It should be noted that the panel signalling and control protocol used
by the Eclipse matrix differs from the Matrix Plus 3. As a result the
operation of these panels with an Eclipse matrix may be slightly
different to their operation with a Matrix Plus 3.
The ICS2x family comprises the ICS-21, ICS-22 and ICS-24 analogue
panels.
Note: The Eclipse matrix may require different code in the
MVX-A16 cards. See the customer release note on the
software CD-ROM.
Eclipse System Requirements for ICS-2x Panels
The Error tones; Call Waiting, Change and Monitoring tones, are
generated on the Eclipse MVX16A card, (for details on Error tones see
the manual for the ICS1008 panel on Eclipse system). The MVX16A
card uses the DTMF plug in boards to do this. These tones require an
MVX16A card with DTMF boards fitted in the appropriate channels,
(standard from 2004).
ECS System Configuration for ICS-2x Panels
ECS panel programming does not support the ICS-21 or ICS-22 or
ICS-24 panels directly. These panels must be set up and configured as
an ICS-1008 panel. In the ECS Matrix Hardware Set-up, configure an
ICS-1008 panel on the required port.
The Talk keys numbered 1-4 on the top row counting from the left
correspond to talk/listen selectors A, B, C and D. respectively.
Only the ICS-24 has selectors A, B, C, and D.
The ICS-22 has A and B.
The ICS-21 has only selector A.
Keys that are not present on a panel are ignored. Assign Talk/listen
labels to the keys as required.
Changes to Matrix+3 ICS-2x Panel operations
The Talk button Latch/Non-Latching operation cannot be defeated in
ECS even for latch disabled labels.