Four-wire trunks, Four-wire trunks -6 – Clear-Com Eclipse-Omega User Manual
Page 356
Clear-Com
Eclipse Configuration Software Instruction Manual
1 0 - 6
systems must also be sequential and incrementing to match the
system numbers. The connection layout is shown below.
Figure 10-6: Fiber Connections
If any four-wire trunked systems are connected to the fiber systems
they should be given higher numbers and their IP addresses should be
above the address range of the fiber linked systems.
Four-Wire Trunks
Select one of the Configurations by selecting the down arrow in the
configuration field at the bottom of the screen.
Open up the Matrix Hardware screen, then select the MVX card where
the trunks are to be configured.
Figure 10-7: Trunk Configuration
• Configure the required ports as Trunks.
• Save the configuration, then switch to the second configuration
• Open Matrix Hardware screen for this configuration and configure the
required ports as Trunks.
System 1
172.20.73.16
System 2
172.20.73.17
System 4
172.20.73.19
System 3
172.20.73.18