Clear-Com Eclipse-Omega - Manual (Page 354)

Clear-Com
Eclipse Configuration Software Instruction Manual
1 0 - 4
• Grey - matrix unavailable or already connected to ECS.
• Green - matrix is connected and available.
Protocols and Port Numbers
The Eclipse system components (matrix and ECS) communicate using
UDP and TCP protocols.
Rack to rack
The volume of traffic both exchanged rack to rack and rack to/from
ECS is not large, there are however of course some points when this is
at a peak. The racks use both directed and broadcast UDP traffic to
communicate.
Broadcast: UDP Port 42001
Directed: UDP Port 42001
Rack to ECS
UDP Port 1300
TCP Port 2048 to TCP Port 2055 inclusive (Lifetime of out of sequence
packets 1 sec).
ALLOCATING A CONFIGURATION TO A MATRIX
To allocate a configuration to a matrix select the matrix by clicking over
the matrix icon in the ‘System’ pane. The matrix will be highlighted by
a green line around the icon.
Click on ‘Matrix Slot’ on the ECS toolbar to open the menu listing the
configuration slots available (normally four) and select the slot for the
configuration.
Right-click on the matrix icon to open the menu and select
‘Configuration’ and then ‘Configuration Manager’ to open the
configuration manager window.
Select the configuration to be applied to the matrix and then click on
the ‘Activate’ button to apply the configuration to the matrix.
Close the Configuration Manager and the name of the selected
configuration will be displayed on the matrix icon.
CLEARING A CONFIGURATION FROM A MATRIX
To clear a configuration from a matrix select the matrix by clicking on
the icon in the ‘System’ pane. The matrix will be highlighted by a green
line around the icon.
Click on ‘Matrix Slot’ on the ECS toolbar to open the menu listing the
configuration slots available (normally four) and select the slot for the
configuration.