Tag tab, Name, Description – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 93: Tag type (read-only)
Publication 1784-UM003A-EN-P – June 2003
The Motion Group 85
Tag Tab
Use this tab to modify the name and description of the group.
Figure 5.7 Motion Group Properties - Tag Tab
When you are online, all of the parameters on this tab transition to a read-only
state, and cannot be modified. If you go online before you save your changes,
all pending changes revert to their previously-saved state.
Name
Enter the name of the motion group. This name must not exceed 40
characters. If you enter more than 40 characters, the system notifies you and it
ignores the extra characters.
Description
Enter a description of the motion group. This description must not exceed 128
characters. If you enter more than 128 characters, the system notifies you and
it ignores the extra characters.
Tag Type (read-only)
Displays the type of tag.
• Base - a normal tag
• Alias - a tag that references another tag with the same definition