Major/minor fault status, Internal state status, Configured – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 85: Owned
Publication 1784-UM003A-EN-P – June 2003
Configuring the1784-PM16SE Card 77
Major/Minor Fault Status
Internal State Status
This field displays the card’s current operational state.
• Self-test
• Flash update
• Communication fault
• Unconnected
• Flash configuration bad
• Major Fault
• Run mode
• Program mode
• (16#xxxx) unknown
If you selected the wrong card from the card selection tab, this field displays a
hexadecimal value. A textual description of this state is only given when the
card identity you provide is a match with the actual card.
Configured
This field displays a yes or no value indicating whether the card has been
configured by an owner controller connected to it. Once a card has been
configured, it stays configured until the card is reset or power is cycled, even if
the owner drops connection to the card.
Owned
This field displays a yes or no value indicating whether an owner controller is
currently connected to the card.
If you are configuring a:
This field displays one of the
following:
digital card
EEPROM fault
Backplane fault
None
analog card
Comm. Lost with owner
Channel fault
None
any other card
None
Unrecoverable
Recoverable