Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 182)

Publication 1784-UM003A-EN-P – June 2003
174 Creating & Configuring Your Coordinate System Tag
The second way is to go the Controller organizer and right click on Controller
Tags and select New Tag from the pop-up menu.
Figure 7.2 Accessing the New Tag Menu From The Controller Tag
The third way also employs the right mouse click method. Right click on the
Motion Group in the Controller Organizer and select New Coordinate System
from the menu.
Figure 7.3 Creating a New Coordinate System From Motion Group
The final way to create a new coordinate system tag is by right clicking on
Ungrouped Axes and selecting New Coordinate System from the menu.
Figure 7.4 Creating a Coordinate System From Ungrouped Axes