beautypg.com

From axis in the controller organizer – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual

Page 269

background image

Publication 1784-UM003A-EN-P – June 2003

Motion Instructions 261

From Axis in the Controller Organizer

You can access the Motion Direct Commands by right clicking on an Axis in
the Controller Organizer. This is the recommended way when you want to
invoke a Motion Instruction for an axis.

Figure 12.5 Controller Organizer | Axis | Motion Direct Commands

This manual is related to the following products: