General tab, Type, Vendor – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 234: Name
Publication 1784-UM003A-EN-P – June 2003
226 Configuring a Kinetix 6000 Drive
The Module Properties screen displays.
Figure 10.6 Module Properties - General Tab
General Tab
The General Tab is where you edit the basic values for the Ultra drive.
Type
Displays the type and description of the module being created (read only).
Vendor
Displays the vendor of the module being created (read only).
Name
Enter a name for the module.
The name must be IEC 1131-3 compliant. This is a required field and must be
completed, otherwise you receive an error message when you exit this tab. An
error message is also displayed if a duplicate name is detected, or you enter an
invalid character. If you exceed the maximum name length allowed by the
software, the extra character(s) are ignored.