Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 51)

Publication 1784-UM003A-EN-P – June 2003
SoftLogix Controller 43
Stored
The workstation date and time when the image was stored in nonvolatile
memory.
Load/Store
Click on this button to access the Load/Store dialog.
This button is disabled when:
• Nonvolatile memory is not present in the controller.
• The controller is in Run mode.
• Another user has locked the controller.
• Redundancy is enabled for the controller.
• The controller is offline.
If the Load/Store button is disabled, the status bar indicates the reason. Note
that the status bar displays only one status at a time, and you must work
through each of them to enable the Load/Store button.