Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 272)

Publication 1784-UM003A-EN-P – June 2003
264 Motion Instructions
Motion Direct Command
Dialog The Motion Direct Commands dialog is similar in position and behavior to
other dialogs in RSLogix5000. The dialog can be accessed when the system is
either off-line or on-line.
Motion Direct Command Dialog
On-line
In order to execute a Motion Direct Command, you must be on-line. The
on-line dialog has the Motion Group Shutdown and Execute buttons active. If
you click on either of these, action is taken immediately.
Figure 12.7 Motion Direct Command Dialog (on-line)
When the Motion Direct Command dialog is opened, focus is given to the
Command Tree. In the Command list, you can either type the mnemonic and
the list advances to the closest match or you can scroll down the list to select a
command. Click on the desired command and its dialog displays.
Instance Designation
Command
Tree
Status Text
Display Area
Action Buttons
Active Command
Operands
Axis or Group Designation