System protocol tab, Common parameters, Protocol – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 30: Station address
Publication 1784-UM003A-EN-P – June 2003
22 SoftLogix Controller
System Protocol Tab
The System Protocol tab allows you to configure the controller’s serial port for
DF1 Point to Point, DF1 Master, DF1 Slave or DH485. The parameters
present on this tab are dependent upon the protocol you select.
Figure 2.6 Controller Properties System Protocol Tab
The parameters present on this tab are dependent upon the protocol you
select.
Common Parameters
Protocol
Choose the protocol from the pull-down menu. Choose from DF1 Point to
Point (default), DF1 Slave, DF1 Master or DH485.
Station Address
Enter the current station link address of the com port to which the DF1 object
is now associated. Valid values are from 0 to 254; the default value is 0.
IMPORTANT
If you wish to configure your system for ASCII, click on
the User Protocol tab.