Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 249)

Publication 1784-UM003A-EN-P – June 2003
Configuring an 8720MC Drive 241
Type
Displays the type and description of the module being created (read only).
Vendor
Displays the vendor of the module being created (read only).
Name
Enter the name of the module.
The name must be IEC 1131-3 compliant. This is a required field and must be
completed, otherwise you receive an error message when you exit this tab. An
error message is also displayed if a duplicate name is detected, or you enter an
invalid character. If you exceed the maximum name length allowed by the
software, the extra character(s) are ignored.
Description
Enter a description for the module here, up to 128 characters. You can use any
printable character in this field. If you exceed the maximum length, the
software ignores any extra character(s).
Node
Select the network node number of the module on the network. Valid values
include those network nodes not in use between 1 to 99.
Revision
Select the minor revision number of your module.
The revision is divided into the major revision and minor revision. The major
revision displayed statically is chosen on the Select Module Type dialog.
The major revision is used to indicate the revision of the interface to the
module. The minor revision is used to indicate the firmware revision.